Consort Claudgen HE6137E 설치 및 제어 매뉴얼 - 페이지 3
{카테고리_이름} Consort Claudgen HE6137E에 대한 설치 및 제어 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Consort Claudgen HE6137E 7 페이지. 3kw low level fan heater with electronic controls and open window detection
페이지 인쇄
SET TIME
PRESS AND HOLD
FOR 5 SECONDS
T
EMPERATURE SET
WHEN DISPLAY SHOWS
ROOM TEMPERATURE,
PRESS TO ADJUST
1. Basic Operation
When the appliance is connected to the mains
supply and the wall socket is switched 'ON', the
display will turn on, showing that the power is
available to the unit. Before you can use the HE6137E,
it has to be activated by pressing any control button.
The LCD backlight will turn on. To operate any control
button, press within 2 seconds of activation.
2. Time and day setting
-
Press and hold the TIME button for 5 seconds.
Minutes are flashing - use TEMP and MODE
buttons to set minutes.
-Press TIME button
Hours are flashing - use TEMP and MODE
buttons to set hours.
-Press TIME button
Day is flashing - use TEMP and MODE
buttons to set Day.
Once you are happy with the settings, press 'Time' to
return to main screen.
3. Selecting operating mode
HE6137E has 4 operating modes:
BOOST, MANUAL, SET BACK, PROGRAM.
Each mode can be selected by pressing the MODE
button to cycle through the options. The cycle
sequence will always start with BOOST mode followed
by MANUAL, SET BACK and PROGRAM.
4. BOOST - 15 minutes
The boost feature increases the room temperature for 15
minutes.
1. Use TEMP and MODE to set the temperature.
To amend the set temperature when in Boost mode,
simply activate the display by pressing any button. Press
TEMP, then use TEMP and MODE to change the
temperature. Once the temperature is set, you can
leave the display to return to the main screen and the
settings will be saved. After 15 minutes, the HE6137E will
return to previous operating mode.
58000386 Iss 02
Time
Prog
Temp
Mode
5. MAN - Manual Mode
In manual mode, the heater maintains the set
temperature.
1. Use TEMP and MODE to set the temperature.
To amend the set temperature when in Manual
mode, simply activate the display by pressing any
button. Press TEMP, then use TEMP and MODE to
change the temperature. Once the temperature is
set, leave the display to return to the main screen and
6. SETB - Reduction in programmed temperature
Setback mode can be used for frost protection, situations
where a minimum room temperature must be
maintained, or to disable the heating completely.
To amend the set temperature when in Setback mode,
simply activate the display by pressing any button. Press
TEMP, then use TEMP and MODE to change the
temperature. Once the temperature is set, leave the
display to return to the main screen and the settings will
be saved. When the room temperature drops below the
set temperature the heating will be active.
To disable heating lower the temperature to below 4ºc
and she screen will show '- - -' The heating is now disable.
7. PROG - Automatic time mode
In this mode, the HE6137E will follow the week's time /
temperature programme.
You can temporarily override the temperature in PROG
mode by simply activating the display and using the
TEMP and MODE buttons to set the new temperature.
The new set temperature will be then maintained until
the next program step.
3
SET PROGRAMME
PRESS AND HOLD
FOR 5 SECONDS
MODE SELECTION
BOOST, MANUAL,
SETBACK AND
PROGRAM