Consort Claudgen HE6137E 설치 및 제어 매뉴얼 - 페이지 4
{카테고리_이름} Consort Claudgen HE6137E에 대한 설치 및 제어 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Consort Claudgen HE6137E 7 페이지. 3kw low level fan heater with electronic controls and open window detection
페이지 인쇄
8. Set 7-day programme
An example of one day programme on HE6137E
PROGRAM 1
ºC
20
19ºC
10
06:00
08:00
Logic diagram for setting programme on HE6137E
PROG
- SET MINUTES
- SET HOURS
- SET DAY
- SELECT DAY TO SET
- SELECT PROGRAM TO SET
- SET MINUTES FOR PROGRAM
- SET TEMPERATURE FOR PROGRAM
The HE6137E has a 7-day timer with up to 6
programming steps available for each day. In the
programming you can set a start time and a
temperature for each programme.
Set programme inactive.
If you do not require the use of all 6 programmes they
can be set as inactive. When in programming mode
select the programme you want to make inactive and
press the TEMP button. If the programme is inactive the
display will show "- -:- -". To activate the programme
again press the TEMP button.
58000386 iss 02
PROGRAM 2
PROGRAM
22ºC
4ºC
12:00
TEMP
MODE
3
4
PROGRAM
16ºC
14:00
16:00
1.
Press and hold PROG for 5 seconds to enter the
time setting.
2.
The day will be flashing.
3.
Use TEMP and MODE to navigate day, press
PROG to select day.
4.
PROG 1 will be flashing. Use TEMP and MODE to
navigate programme, use PROG to select
programme.
5.
The minutes will be flashing.
6.
To set minutes, use TEMP and MODE to change
minutes, press PROG to set the minutes.
7.
The hour will be flashing
8.
To set hour, use TEMP and MODE to change
hour, press PROG to set the hour.
9.
The temperature will be flashing.
10. To set temperature, use TEMP and MODE to
change temperature, press PROG to set
temperature.
To add another programme repeat steps 2-10.
Copy day function.
If you require the same set of programmes throughout
the week it is possible to copy all the programmes
from one day to another.
To do this, when in programming mode press and
hold the TIME button and this will bring you to the
copy day mode. To select which day you wish to
copy press the PROG button and this will cycle
through numbers 1-7 on the screen, this relates to
which day you would like to copy. 1=MON, 2=TUE,
3=WED etc.
To select which day you would like to copy the pro-
grammes to, use the TEMP & MODE to navigate to the
day. Once both are selected, press the time button
to copy the day.
12. Status light on the heater
PROGRAM 5
PROGRAM 6
22ºC
10ºC
22:00
STAND-BY No heat output
Reduced heat output
Full power heat output
5