Constellation Pictor 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Constellation Pictor에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Constellation Pictor 17 페이지. Line stage preamplifier

Input setup

When you press the multifunction button labeled Setup on the input screen, this

screen will appear. It allows you to set up a home theater bypass input, and set

minimum and maximum output levels.

To set minimum and/or maximum levels: Adjust the Pictor's volume to the

desired minimum or maximum level, and press either the Set Min or Set Max

button, depending on which function you want, and hit Apply to accept the

setting. To clear the setting, press either CLR Min or CLR Max as appropriate, or press Default to clear both

settings.

To set up a home theater bypass input: First select the input you want to use for this function, then adjust the

volume on the Pictor to the desired level. Push the Set Min button, then the Set Max button, then the Apply

button. To clear these settings, press CLR Min then CLR Max, or press Default.

Screen setup

To adjust LCD brightness: Press the + and – buttons on the left side of the screen,

on either side of the dark dot.

To adjust LCD contrast: Press the + and – buttons on the right side of the screen,

on either side of the half-dark/half-light dot.

To adjust LCD backlight timeout: Press the Timeout button in the lower left

corner to keep the screen lit for 15 sec., 30 sec., 1 min., 5 min., 10 min., and

always on.

To accept or cancel screen setting changes: Press the Apply or Cancel button, respectively.

To return to the factory default settings: Press the Default button. This will bring up a screen asking "Are you

sure you want to set this device to its default settings?" Hit the Yes button to go to default settings, the No

button to cancel.

Product info

This screen is accessed using the multifunction button labeled Info on the screen

setup screen. It is for servicing use only.