Constellation audio Inspiration PREAMP 1.0 사용자 설명서 - 페이지 5

{카테고리_이름} Constellation audio Inspiration PREAMP 1.0에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Constellation audio Inspiration PREAMP 1.0 16 페이지.
Constellation audio Inspiration PREAMP 1.0에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄

Location

The Inspiration MONO 1.0 and Inspiration STEREO 1.0 must be installed in an area with adequate ventilation.

There should be at least 6 in/15 cm of clearance between the vents on the side of the amplifier(s) and the

nearest wall or cabinet. Ensure that no curtains or shades can be lowered in a way that will block the

amplifier's vents. If the amplifier is installed in a cabinet or in an equipment closet, ensure that the

cabinet/closet has adequate ventilation. Installation in an unventilated cabinet or closet may cause the

amplifier to overheat.

These amplifiers require a room-temperature environment to operation properly. Ambient temperature

should be about 70°F/21°C, plus or minus 10°F/5°C. Never install the amplifier in a place where it may be

exposed to direct sunlight, and do not install it next to a room heater, radiator, air conditioner, etc. Ambient

temperature can rise even more quickly with two Inspiration MONO 1.0s, so if you place both of them in an

enclosed or tight space, make extra sure to provide plenty of ventilation and air flow.

Make sure that the amplifier will not be exposed to moisture. Do not locate it in an area where it might be

spilled on, and do not place it in a humid location (such as an unfinished basement).

Installing the Inspiration MONO 1.0 or Inspiration STEREO 1.0 in a place where it will be exposed to direct

sunlight or moisture, or where it will not have adequate ventilation, will void your warranty.

Speakers

The Inspiration MONO 1.0 and Inspiration STEREO 1.0 produce sufficient voltage and current to drive

practically any loudspeaker made, regardless of the speaker's impedance, sensitivity, or power rating.

However, the Inspiration STEREO 1.0 and, especially, the Inspiration MONO 1.0 have enough power to

damage some loudspeakers if used carelessly. When you turn up the volume on your preamp, do it gradually.

If you hear distortion, crackling noises, or mechanical thumps from the speaker, turn the volume down

immediately.

You can best appreciate the amplifier's performance by connecting it to a large set of full-range

loudspeakers. It will sound excellent with small speakers, too, but if you connect it to a small set of speakers,

avoid turning the volume on your preamp to maximum.

Constellation Audio is not responsible for damage of any speaker connected to the Inspiration MONO 1.0 or

Inspiration STEREO 1.0.

In the event of malfunction

Do not under any circumstances open the cabinet of the amplifier. There are no user-serviceable parts inside.

Opening the cabinet can present a shock hazard even if the AC power is disconnected. Any alteration or

modification of the amplifier's internal parts or circuit will immediately void your warranty.

If your amplifier does not function correctly, refer to the Troubleshooting section at the end of this manual. If

you are still unable to resolve the problem, contact your authorized Constellation Audio dealer.

If any liquid is spilled on the amp, or if any metal object (such as a staple or a paper clip) is inadvertently

forced in through the vents, immediately disconnect the AC power and contact your authorized Constellation

Audio dealer.