Constellation audio Inspiration PREAMP 1.0 사용자 설명서 - 페이지 8

{카테고리_이름} Constellation audio Inspiration PREAMP 1.0에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Constellation audio Inspiration PREAMP 1.0 16 페이지.
Constellation audio Inspiration PREAMP 1.0에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄

5. 15-amp IEC AC socket

Connect the supplied 15-amp AC cord

here. You may also use an aftermarket

power cord if you wish.

6. USB service input

This input is exclusively for use by

Constellation Audio and your

Constellation Audio dealer. It is used for

firmware updates to the amplifier.

7. Trigger input

This 3.5mm jack accepts a 12-volt DC on/off trigger signal from preamps and third-party control systems.

When a 12-volt DC trigger signal is input to the jack, the Inspiration STEREO 1.0 will turn on. When the trigger

signal stops, the amplifier will turn off.

Controls / displays / indicators

8. Front power/mute switch

The bar running across the front of the amplifier is the power/mute switch. Press on the left end of the bar

and hold it for 3 seconds to turn the amp on and off. Press and release the left side of the bar to activate and

deactivate mute mode.

9. Status indicator LED

This LED shows if the amp is on or off, and also

indicates mute, warm-up, and cool-down

modes. Here are the LED modes:

SOLID RED: Standby mode. Amp is powered

down but ready to use.

FLASHING RED: Cool-down mode. Amp is

powered off but cooling down. The power

button cannot be used in this mode. This mode

lasts 1 minute.

FLASHING GREEN: Warm-up mode. Amp power

is on but amp is warming up and cannot be

used. This mode lasts 1 minute.

SOLID BLUE: On mode. Amp power is on and

the amplifier is fully functional.

FLASHING BLUE: Mute mode. Amp is powered

but will produce no sound.