Constellation audio Virgo 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Constellation audio Virgo에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Constellation audio Virgo 18 페이지.

Before you install the Virgo II

Take care when you remove the Virgo II from its packaging. Because of its machined aluminum top chassis, it

is heavier than the average preamp. Have an extra person nearby to help if you need it. You may wish to use

gloves to protect your fingers.

The Virgo II's separate power supply (bottom component in the picture above) must be connected to the Virgo II

main chassis (top component in the picture above) as shown above before you plug the unit into a wall. Make

sure the power switch on the power supply is in the off (O) position. The supplied cables are spiral-wrapped,

gold-plated copper designed for aerospace use, and can handle up to 30 amps. Only these cables should be

used between the power supply and the Virgo II.

Connect the Analog Right power cable from the supply to the Analog Right jack on the preamp, the Analog Left

power cable from the supply to the Analog Left jack on the preamp, and the Control power cable from the

supply to the Control power jack on the preamp. At this point you can plug the Virgo II power supply into the

wall socket. Leave the master power switch off until you connect your other equipment to the Virgo II.

DO NOT remove the power cables while the unit is powered on. If you do happen to accidently pull one of them

out, DO NOT plug it back in. Turn off the power supply using the hard switch on the rear panel, unplug the unit,

then replace the cable. Failure to power down the unit before replacing a power cable can result in substantial

damage to your Virgo II.

If you will be using the Constellation Audio Centaur or Hercules amplifiers (or any other high-powered

amplifier), do not plug the Virgo II into the same AC socket or into any other outlet connected on that circuit.

Constellation Audio amplifiers draw a great deal of power and could affect the Virgo II's performance if the

amplifier(s) and preamp are plugged into the same electrical circuit or AC outlet.

When you connect or disconnect the AC cord, always grasp it by the plug, not by the cord itself. Pulling the plug

out by the cord can damage the cord, the AC socket, and/or the Virgo II.