Constellation audio Virgo 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Constellation audio Virgo에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Constellation audio Virgo 18 페이지.

Source device and amplifier connections

On the rear of the Virgo II preamp there are eight XLR inputs, four on each side. As you are looking at the rear

panel, the left four XLR inputs are for the right channel, the right four inputs are for the left channel.

Underneath each jack is the corresponding input number. Use of XLR connections is recommended for the

best possible audio quality. To remove an XLR plug, push on the tab above the jack and pull the plug out.

IMPORTANT NOTE: To preserve true dual-mono operation, the Virgo II uses a symmetrical circuit layout. This

configuration requires that the Virgo II's back panel connections be laid out a little differently from those on

most preamps. For example, the left-channel connection for Input 1 is at the far right side of the back panel,

and the right-channel connection is at the far left side. Connecting the cables in the usual side-by-side fashion

will result in an incorrect installation and the mixing of sounds from different source devices.

The input numbers from left to right, looking at the back of the Virgo II are:

, 2

, 3

, 4

right

These unbalanced inputs are provided as a convenience for use with unbalanced signal sources. Whenever

possible, we recommend using XLR connections instead. Connecting to an unbalanced source is handled in

the same way an XLR balanced source.

The input numbers from left to right, looking at the back of the Virgo II are:

, 6

, 7

, 8

right

IMPORTANT NOTE: To preserve true dual-mono operation, the Virgo II uses a symmetrical circuit layout. This

configuration requires that the Virgo II's back panel connections be laid out a little differently from those on

most preamps. For example, the left-channel connection for Input 5 is at the far right side of the back panel,

——4

, 3

, 2

, 1

right

left

——8

, 7

, 6

, 5

right

left