Abus TVAC71070 사용자 설명서 - 페이지 11

{카테고리_이름} Abus TVAC71070에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Abus TVAC71070 14 페이지.
Abus TVAC71070에 대해서도 마찬가지입니다: 빠른 매뉴얼 (4 페이지)

Installation

1. Attach the illuminator mount to pan/tilt unit, wall or camera housing. Using

stainless steel fixings suitable for the relevant application.

2. Connect the lamp to a suitable (SELV) low voltage supply. Ensure that the

polarity is correct.

3. Commission the mains supply, camera and monitoring equipment.

4. Select the diffuser angle sheet required from the scope of delivery (if required).

To position the required diffuser sheet, insert the tool included in the slot at the

bottom of the cover and prise upwards slowly. Repeat at opposite end and

carefully remove cover. Remove backing sheet from the two adhesive discs

and secure required diffuser in position. Finally firmly clip the lens cover back

into place.

5. Adjust the pan angle of the illuminator to match the camera field of view.

6. Adjust the vertical alignment by loosening the side bolts (one on each side of

the main body) to maximise the results.

7. SLOWLY and GRADUALLY tilt the lamp upwards until the for part of the

required field of view is illuminated correctly on the monitor.

The Illuminator may be activated remotely by a volt-free contact latched across the

telemetry wires (see Diagram above).

Volt-free relay contact-normally open (day) to normally closed (night). See Diagram

above.