AudioStak ProSwitch PRSW-MONO-PCB 매뉴얼 및 설치 매뉴얼 - 페이지 8

{카테고리_이름} AudioStak ProSwitch PRSW-MONO-PCB에 대한 매뉴얼 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioStak ProSwitch PRSW-MONO-PCB 20 페이지.

Groups

In a ProSwitch system, audio/video products must be arranged into Groups of similar devices. For example,

head units would be one Group, front speakers would be another. Each Group is then given a Group Number,

which set through the DIP switches on the Main Modules (PRSW-MCU-PCB). ProSwitch systems can have up to

16 groups of speakers, and up to 16 groups of components. A 'component' is any non-speaker device.

Boards

Within each Group it may be necessary to use multiple Main Modules depending on the number of products

involved. Each Main Module is able to switch up to four products. For each additional four products in that

Group, one more Main Module is needed. ADD-ON modules are connected to each Main Module to switch the

signals required by that Group. Each Main Module within a Group is given its own number, called its Board

Number. This is set using its Board Number DIP switch.

Positions

Each Main Module, together with its attached ADD-ON modules can switch up to four devices (speakers or

components). The signal connectors on the ADD-ON modules and the button connectors on the Main Modules

are all labelled A through D, and are referred to as Positions. When a button connected to Main Module is

pressed, all the signal connectors on its attached ADD-ON modules with the same Position number are selected

and become active. Each component must have all its signal connectors connected to the same position, A, B,

C, or D, on each ADD-ON module.

For example, in a 2-channel amplifier Group each Main Module would use two ADD-ON modules: one 4L

module (PRSW-RCA-PCB) for RCA inputs, and one 4H module (PRSW-4HL-PCB) for high level outputs. When the

button connected to Position A on the Main Module is pressed, Position A on that Board becomes active, and

all other Positions within that Group are deselected and disconnected. The RCA inputs for that amplifier

connected to Position A on the 4L board will become active, as well as its high level outputs connected to

Position A on the 4H board.

The signal connectors for the four Positions on each ADD-ON module can be used for either input or output

signals. For example, 4H modules are used to switch the high level outputs from head units and amplifiers, as

well as the high level input signals to speakers.

Overview – Groups, Boards and Positions