Contacta PLALS-V 설정 매뉴얼 - 페이지 5

{카테고리_이름} Contacta PLALS-V에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Contacta PLALS-V 8 페이지. Portable large area loop

Installation & Testing Instructions

Note: Consult the provided Chord NU2 Multi-Frequency Receiver and

V7 Hearing Loop Driver's user guides if instructions are required.

Run the provided hearing loop cable around the area you wish to

loop, ensuring that it is taped down securely. Do not leave any

trailing leads that may cause a trip hazard.

2. Connect the hearing loop cable to the loop input connector on the

rear of the Portable Large Area Loop.

3. Unpack the 2 aerials from the accessory pouch. Connect them to

aerial connection #1 and #2 on the front of the Portable Large Area

Loop.

4. Connect both the V7 power supply and the Chord NU2 power

supply to their respective power supply inputs on the rear of the

Portable Large Area Loop; then connect the power supplies to a

mains power source.

5. Power on the Chord NU2 Multi-Frequency Receiver.

6. Unpack the Handheld Microphone from the accessory pouch and

turn the power on. The Channel A/B "RF" LED on the Chord NU2

will light up once the Handheld Microphone has been powered on.

7. Unpack the Loop Listener from the accessory pouch and turn the

power on. Connect it to the provided headphones.

8. While using the Loop Listener, speak into the Handheld

Microphone. Ensure the signal strength of the hearing loop meets

requirements.

9. If necessary, adjust the signal strength of the hearing loop using

the V7 Hearing Loop Driver to achieve required levels. For detailed

instructions, consult the provided V7 user guide.

10. Installation and testing is now complete.