3xLogic infinias eIDC32 빠른 시작 매뉴얼 - 페이지 11
{카테고리_이름} 3xLogic infinias eIDC32에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3xLogic infinias eIDC32 17 페이지.
페이지 인쇄
- 1. Important Safety Instructions
- 2. Before You Begin
- 3. Installation
- 4. Connect to an Ethernet Switch
- 5. Poe SWITCH
- 6. NON-Poe with MIDSPAN Poe INJECTOR
- 7. NON-Poe SWITCH
- 8. NON-Poe with POWER INJECTOR
- 9. DETERMINE the Eidc IP ADDRESS
- 10. CONFIGURE the Eidc with the WEB SERVER
- 11. CONNECT to the Eidc
- 12. CHANGE the Eidc to DHCP or STATIC IP MODE
- 13. WIRE the Eidc DOOR COMPONENTS
- 14. Eidc Web Server: Single Door Application
WIRE THE eIDC DOOR COMPONENTS
Up to 750 mA of power is provided through the eIDC for peripheral
devices. Figure 2 illustrates how to wire the eIDC for a single door.
Optional
PCON
Power Connector
To Ethernet Hub
Door Strike
Door Contact
Card Reader
or Keypad
To Reader LED Output
Optional External
Power Supply
24 vDC, 1 Amp
To Ethernet Hub
Note: The eIDC device and its
UL listed Power Supply must be
installed within the protected area
(locked area) of the access facility
to meet UL requirements.
Note: To meet UL requirements,
listed panic hardware must be
used to allow emergency exit from
the protected area.
QSG-002 / 01-03-2017
Ethernet
Connection
Output 1
Output 2
Input 1
Common
Input 2
Card Reader
IN
Power
Output 1
24V DC IN
CAT 5/6
Figure 2. eIDC Wiring for a Single Door
Built-in
Infrared Tamper
Output 3 - NC
Common
Output 3 - NO
Input 3
Common
Input 4
Card Reader
OUT
Power
Output 2
Reader LED Output
Reader Buzzer Output
Built-in
Warning Buzzer
Note: Maglock is required
to have additional external
power supply.
Electro-magnetic
Lock
Card Reader
or Keypad
eIDC
Built-in
Warning Buzzer
11