Audiothingies Doctor A 빠른 시작 매뉴얼 - 페이지 3
{카테고리_이름} Audiothingies Doctor A에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiothingies Doctor A 4 페이지.
Audiothingies Doctor A에 대해서도 마찬가지입니다: 수동 부록 (3 페이지)
페이지 인쇄
Changing the Delay mode
ACCESS & EXIT: Hold DELAY (Delay LED will blink when activated)
Use the 4 SETUP/RECALL buttons to switch modes, the corresponding LED will blink to show
the currently active mode. The available modes are:
● ○ ○ ○
Lo-Fi
○ ● ○ ○
Classic
○ ○ ● ○
Spacey
○ ○ ○ ●
Ping-pong
TIP: In Ping-pong mode, you can access the L/R delay time offset with TAP + Feedback pot.
Set it to 12 o'clock to get the traditional ping-pong effect, experiment with the other positions to
get some cool L/R rhythmic effects.
Changing the Reverb mode
ACCESS & EXIT: Hold REVERB (Reverb LED will blink when activated)
Use the 4 SETUP/RECALL buttons to switch modes, the corresponding LED will blink to show
the currently active mode. 2 layers with 4 modes each are available.
Switch between the 2 layers by holding one of the 4 SETUP/RECALL buttons
Layer 1 modes
● ○ ○ ○
Small A
○ ● ○ ○
Medium A
○ ○ ● ○
Roomy
○ ○ ○ ●
Bouncy
Layer 2 modes
○ ● ● ●
Plate
● ○ ● ●
Vocal plate
● ● ○ ●
Hall A
● ● ● ○
Concert Hall
Changing the System settings
ACCESS & EXIT: Hold DELAY + REVERB (both Delay and Reverb LEDs will blink)
In this submode, each one of the SETUP/RECALL LED/button show/change a system
parameter:
8-bit delay
12-bit delay
12-bit delay, tape-vibe, self oscillates more easily
The obligatory ping pong delay, with different L/R times
Short size room reverb
Medium size room reverb
Very colored small room reverb, great for drum loops
Ringy and very fun reverb algorithm
The classic plate reverb
Plate reverb with less diffusion
Large size room reverb
The largest available algorithm, a concert hall reverb