Audiovalve ASSISTENT 100 Mark 2 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Audiovalve ASSISTENT 100 Mark 2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiovalve ASSISTENT 100 Mark 2 18 페이지. Integrated stereo triode tube amplifier

페이지 인쇄

Assistent 100 – Mark 2

integrated tube amplifier_

___________

REAR PANEL

all possibilities to connect your amp ...

INPUT TERMINALS

The 5 pair RCA and 2 pairs XLR Inputs are standard terminals for the

use of unbalanced and balanced input signals coming from the signal sources . The

ASSISTENT 100 uses for all fage XLR inputs female jackets and for the TAPE output one

pair of RCA jackets.

OUTPUT TERMINALS

The ASSISTENT 100 Mark 2 has two pair of output terminals in vertical direction for 8

ohm loads, you can internal switch to 4 ohm speakers

PLACEMENT AND VENTILATION

This AudioValve ASSISTENT 100 amplifier is designed to

operate at a moderately high temperature. The ideal location

is on the rigid stand or floor mounted away from direct contact with any objects,

materials or deep pile carpets which may be effected by the heat or which may interrupt

the flow of air around the amplifier.

When operating the amplifiers quite a lot of heat is generated which should be allowed to

dissipate without restriction. Make sure that no objects are placed on the top of the

amplifier. Always ensure adequate ventilations.