Audiovalve CORDA EARTUBE-1 사용자 설명서 - 페이지 4

{카테고리_이름} Audiovalve CORDA EARTUBE-1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiovalve CORDA EARTUBE-1 11 페이지. Small-power amplifier specially designed to drive headphones

페이지 인쇄

Connections

At the rear side of the CORDA EARTUBE-1 two pairs of inputs allow you to connect two different

audio sources that have typical output voltages above 0.1 Volts (CD-player, cassette-player, tuner,

minidisc-player, ...). The source you want to listen to can be selected by the switch at the left front side

of the amp.

If your audio system already contains a central preamplifier or integrated amplifier you may prefer to

connect the EARTUBE-1 to the tape-out of your central amplifier. The source now can be selected by

the Rec-switch of this central amp.

Your headphone should be connected to one of the headphone-sockets on the front side of the

EARTUBE-1. You can also use the sockets to connect two headphones simultaneously.

The sockets are intended for 6.35 mm stereo jacks. If your headphone only has a 3.5 mm jack, then

use an adapter that can be obtained in most electronics or audio shops.