DAPAudio HM-30 매뉴얼 - 페이지 7

{카테고리_이름} DAPAudio HM-30에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio HM-30 10 페이지.
DAPAudio HM-30에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지)

Set Up and Operation

Set all volume and gain controls on your mixer, mic preamp or recording device are at their minimum

settings before connecting the microphone. Make sure the phantom power is turned off!

Once the HM-30 is plugged in, move the channel fader gradually to the 0dB position adjust the input

gain using your channel peak led or VU-meter.

Take care of the connector cables, always holding them by the connectors and avoiding knots and

twists when coiling them: This gives the advantage of increasing their life and reliability.

Periodically check that your cables are in good condition, that they are correctly wired and that all their

contacts are in good condition: a great number of problems (faulty contacts, ground hum, discharges,

etc.) are caused entirely by using unsuitable or faulty cables.

Headphones

Unbalanced mono 1/4" jack plug Balanced mono 1/4" jack plug