DAPAudio COM-52 제품 설명서 - 페이지 7

{카테고리_이름} DAPAudio COM-52에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio COM-52 19 페이지.

Fig. 3

11) Antenna B

12) Unbalanced 1/4" jack plug

13) Balanced XLR Connector

14) Mixed Channels Audio Output Connector: Unbalanced 1/4" jack plug connector mixes both

channels into a single output.

15) Power Input Connector 12V 600mA

16) Balanced XLR Connector

17) Unbalanced 1/4" jack plug

18) Antenna A

Installation

Remove all packing materials from the Com-52. Check that all foam and plastic padding is removed. Put

the 2 antennas into socket A and B at the backside in a vertical angle. Remove the rubber protection

caps at the underside of the microphones that covers the recharge inputs (See Fig 4).

Fig. 4

When connecting the powersupplies, assure yourself that the right supplies are connected to the right

devices. Look at the red/green sticker at the bottom of the microphone.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.