DAPAudio COM-52 제품 설명서 - 페이지 9

{카테고리_이름} DAPAudio COM-52에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio COM-52 19 페이지.

Sensitivity Adjustment Menu (SQUELCH)

Press SET, the LCD shows:

after a second the display shows:

This menu is for adjusting the sensitivity (Mute Control). It is used to stregthen the system's capacity of

preventing disturbing: The range is from 0 – 40 dB. The greater the value, the lower the sensitivity is. Nearer

distance, stronger capacity of preventing disturbance. On the other hand, a lower value (Minimum

15dB), higher sensitivity and farther distance, but the capacity of preventing disturbance will reduce.

Usually, the normal setup is 20 dB (Factory is 15dB).

Press UP/DOWN to change the settings. After changing the settings, please press the SET button to

confirm. Otherwise it won't effect and the system will remain in the precious state.

When you have selected a new channel or frequency and you haven't pressed SET, the LCD will flash to

remind you. When you press SET, the LCD stops flashing.

Signal Channel solution Menu

Press SET, the LCD shows:

after 3 seconds the display shows:

Note: Which screen is shown, depends on the previous setup.

When you press UP / DOWN, the LCD indicates 2 modes as Channel or Frequency. If you select channel,

CHANNL is shown as numerical value. If you select FREQU, it is shown as actual working frequency. After

selecting, you must press SET. Otherwise, your setting is not stored.

After you change and you don't confirm, the LCD flashes as a reminder. Press SET and the LCD will stop

flashing.