Duratool D03305 빠른 시작 매뉴얼 - 페이지 7
{카테고리_이름} Duratool D03305에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratool D03305 8 페이지.
페이지 인쇄
•
If several cables are not connected, their respective LEDs will not light.
•
If less than two cables are connected, none of the LEDs will light.
•
If two ends of a cable is crossed over, for example No.2 and No.4, then
displays on:
Main Tester:
Remote Tester:
•
The tester can be used to test installed network cabling between wall sockets
by using a matched pair of RJ45 or 110P4 cables between wall sockets and
tester.
BATTERY REPLACEMENT
•
If "
" appears in display, it indicates that the battery should be replaced.
•
To replace battery remove the meter from the protective surround, then
remove the 2 screws in the rear of the case
•
Remove the rear case half and simply remove the old battery, and replace with
a new one. (9-volt battery, NEDA 1604 6F22 type)
•
Be careful to observe correct polarity.
•
Fuses rarely need replacement and blow almost always as a result of operator
error. (F500mA/500V for mA terminal and F5A/500V for 5A terminal).
1-2-3-4-5-6-7-8-G
1-4-3-2-5-6-7-8-G
7