DAPAudio D1256 매뉴얼 - 페이지 14

{카테고리_이름} DAPAudio D1256에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio D1256 16 페이지.

Maintenance

The

DAP Audio CDR-110 MKII

Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in

liquid. Do not use alcohol or solvents.

Keep connections clean. Disconnect electric power, and then wipe the audio connections with a damp

cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric power.

Replacing a Fuse

Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the

fuse burns out, the product will not function whatsoever. If this happens,

so.

1. Unplug the unit from electric power source.

Insert a flat-head screwdriver into a slot in the fuse cover. Gently pry up the fuse cover. The fuse will

come out.

3. Remove the broken fuse. If brown or unclear, it is burned out.

4. Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover.

Be sure to use a fuse of the same type and specification. See the product specification label for

details.

DAP Audio CDR-110 MKII.

This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps

below in sequence until a solution is found. Once the unit operates properly, do not carry out following

steps.

1. If the device does not operate properly, unplug the device.

2. Check power from the wall, all cables, connections, etc.

3. If all of the above appears to be O.K., plug the unit in again.

4. If nothing happens after 30 seconds, unplug the device.

5. Return the device to your DAP Audio dealer.

requires almost no maintenance. However, you should keep the unit clean.

follow the directions below to do