Duratool D03410 매뉴얼 - 페이지 3
{카테고리_이름} Duratool D03410에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratool D03410 4 페이지. Weighing scale
페이지 인쇄•
Press [M] key to set the correct sample amount of items that you have put onto the
platform.
•
Briefly press [PCS] key to confirm the above information, the LCD will now display
"PCS" solid in the corner to show that the scale is in counting mode.
•
Remove the sample quantity from the platform.
•
Now can place any amount of your item(s) on the scale and the LCD will display a
count.
•
You can switch between weighing mode and counting mode by pressing [M] or
[PCS] key respectively.
CALIBRATION
NOTE Calibration is not required before initial use but only if "out2" is displayed or at
intervals as a check to ensure accuracy.
•
Reset the scale by pressing [ON/OFF] key.
•
Wait until the LCD displays "0.0" and then press and HOLD [M] key for 3 seconds.
•
The LCD will display "Zero" followed by the required calibration weight.
•
Add the required calibration weight, the display will show "PASS" and return to
normal weighing mode.
•
Store the calibration weight safely and press [ON/OFF] to turn off the scale and the
calibration is complete.
BATTERY REPLACEMENT
•
When LCD display starts to fade, it is necessary to replace the batteries. However,
measurement may still be made for several hours although accuracy cannot be
guaranteed.
•
Slide the battery cover away from the instrument and remove the batteries.
•
Replace with new AAA batteries noting the correct polarity and refit the cover.
MAINTENANCE
Cleaning the casing
•
Wipe using a moist cloth or sponge. Do not use solvents as these may damage the
casing.
•
Avoid scratching the LCD screen.
•
Do not immerse in water or allow moisture to enter the casing.
3