Addonics Technologies ADM218SA 매뉴얼

{카테고리_이름} Addonics Technologies ADM218SA에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Addonics Technologies ADM218SA 2 페이지. M2 - 1.8" micro sata adapter

INTRODUCTION
This M2 - 1.8" Micro SATA adapter is designed to enable M2 SSD, with
length of 30, 42 or 60 mm, to be used as a direct replacement of the
1.8" micro SATA hard drive. As a result, any equipment, such as
Notebook computer, iPOD that uses a 1.8" SATA hard drive can be
easily converted to use the low power and shock resistant M2 SSD, just
like a SATA solid state drive (SSD). Once installed, the M2 appears as
an ordinary SATA hard drive to any OS and can be configured as a boot
device.
This M2 adapter, coupled with the micro SATA - 2.5" HDD adapter, can
also be used like a removable flash media in the Addonics Pocket
UDD25 or Internal UDD25
access to the M2 SSD via USB 3.0 / 2.0 or eSATA connection to any
computer.
M2 SSD installation and overview of the M2 - Micro SATA adapter assembly procedures
(Note that the M2 SSD shown in the diagram below is for illustration purpose and is not part of the product)
Insert the M2 SSD into the M2 socket at ~ 40° angle as shown in arrow 1.
Push down the M2 SSD as shown in arrow 2 and secure the media with the screw provided
M2 - 1.8" Micro SATA adapter
reader/writer, allowing easy read/write
The1.8" M2 adapter is designed with the same connector location and dimension as a 1.8" micro
SATA hard drive. It is a perfect solution for replacing the micro SATA hard drive with the low power
and shock resistant M2 media.
Model: ADM218SA