DAQ system NET-AIO11 사용자 설명서 - 페이지 5

{카테고리_이름} DAQ system NET-AIO11에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAQ system NET-AIO11 12 페이지.

3. Hardware Device

In this chapter, board jumper set and connector for interfaced the PC or other operation

equipment is described.

Ethernet

Connector

POWER

Connector

USB-B

Connector

LED

(PWR,RUN)

3.1 DSP Mode Setup Jumper (J2)

The execution mode of the board is the USB boot mode and flash boot mode. The Flash

boot mode (jumper OFF) is the general board operation. On the other hand, the USB boot

mode is used when frequent firmware updates or develops flash memory program.

3.2 USB-B Connector (CN1)

It is a B-type USB connector. It is connected to a PC and is done a data transmission.

3.3 LED(PWR, RUN) (D22)

The power and status of board is displayed. When connecting the power, the red led

light on. When collecting the data, the green led light on.

DSP Mode

Setup Jumper

[Figure 2. Connector, Switch Placement]

NET-AIO11 User's Manual (Rev 1.0)

AIN

Connector

Reset Switch

http://www.daqsystem.com