DAQ system NET-AIO11 Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Компьютерное оборудование DAQ system NET-AIO11. DAQ system NET-AIO11 12 страниц.

3. Hardware Device

In this chapter, board jumper set and connector for interfaced the PC or other operation

equipment is described.

Ethernet

Connector

POWER

Connector

USB-B

Connector

LED

(PWR,RUN)

3.1 DSP Mode Setup Jumper (J2)

The execution mode of the board is the USB boot mode and flash boot mode. The Flash

boot mode (jumper OFF) is the general board operation. On the other hand, the USB boot

mode is used when frequent firmware updates or develops flash memory program.

3.2 USB-B Connector (CN1)

It is a B-type USB connector. It is connected to a PC and is done a data transmission.

3.3 LED(PWR, RUN) (D22)

The power and status of board is displayed. When connecting the power, the red led

light on. When collecting the data, the green led light on.

DSP Mode

Setup Jumper

[Figure 2. Connector, Switch Placement]

NET-AIO11 User's Manual (Rev 1.0)

AIN

Connector

Reset Switch

http://www.daqsystem.com