Duratuf Garrison PL36 조립 지침 매뉴얼 - 페이지 11

{카테고리_이름} Duratuf Garrison PL36에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf Garrison PL36 16 페이지. Base size: 1.020m x 2.020m

ASSEMBLE FRONT PANEL

SELECT:

1 x 1.020 Top Plate (Red)

1 x 1.020 Bottom Plate (Green)

2 x 1.980 Corner Door Jamb Flashing

4 x 30mm Galv Clouts

9 x Rivets

STEP 1:

• Lay out 1 x Top Plate and 1 x Bottom Plate on a flat

surface as shown

STEP 2:

• Using 2 x 30mm clouts, nail the Door Jamb Flashing flush with

the top of the Top Plate at the correct measurement as shown

in plan view. Pre drill holes using a 3.5mm drill bit.

• Check the distance between the top and bottom plates then use

a further 2 x 30mm clouts to nail the Door Jamb Flashings to

the bottom Plate. Pre drill holes.

NOTE:

Door can be hinged on either side.

STEP 3:

• Place the door on the panel (In open position, approx

20mm below top of top plate). Using two rivets, rivet the top

and bottom hinges to the Door Jamb Flashing, ensuring

door closes properly.

• Fit remaining rivets.

IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER

BASE PLATE –READ THE FOLLOWING;

For sheds with Raised Base Plate option only (see page 6), deduct

30mm from measurement shown between Top and Bottom Plates on

all wall panels, so cladding protrudes 20mm below bottom plate

1948mm

15mm

TOP PLATE

1948mm

BOTTOM PLATE

Plan View

15mm

TOP PLATE

DOOR OPENING

960mm

TOP

PLATE

NAIL

DOOR

JAMB