Duratuf GG97 조립 지침 매뉴얼 - 페이지 14

{카테고리_이름} Duratuf GG97에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf GG97 16 페이지.

ROOF ASSEMBLY CONT...

STEP 3:

• Ensure shed is sitting level and square.

• Beginning from the left hand end (looking from front)

centralise the Roof sheets on the Ridge Beam.

• Ensure that the Roof is tight against the Gable Wall Sheets. Screw 1 x 55mm Roofing screw through the 1st pan into the

Ridge Beam. (a - fig.2).

• At the back left hand corner, (from front) line up the ribs on the Roof Sheet with the ribs on the Wall Sheet then using 1 x

50mm Clout, predrill and nail Roof Sheet through the rib into the Top Plate. (b– fig.2.)Repeat at the front left hand cor-

ner. (c - fig.2).

STEP 4:

• Centralise the Roof at the other end (R/H end) with the Ridge Beam.

• Using 1 x 55mm Roofing Screw, fix roof sheet though the pan, to the other end of

Ridge Beam. (d–fig.2).

• Using 2 x 50mm Clouts fix sheet though rib to front & back Top Plates. (e–fig.2).

• Ensure that the Ridge Beam is straight, screw roof sheets to ridge beam beside

each overlap, through the pan using 4 x 55mm Roofing screws.

• Ensure the Front and Back Top Plates are straight. Screw the roof sheets to the

front & back Top Plates, through the ribs, using 1 x Roofing Screw per rib. (fig.1).

STEP 5:

• Place barge flashings on roof at end of

shed ensuring the diagonal trimmed end is

facing out. (See diagram on pg 5)

• Rivet the Barge Flashings to the roof and

the side wall, using four rivets on top of

barge and four into the side (fig.3).

STEP 6:

• Rivet the 2 Ridge Caps together using 4

rivets, so total flashing is 2.720m long.

Rivet the Ridge Cap to the centre of the

roof using 8 x rivets as shown (fig.2).

STEP 7:

• Place spouting in position and rivet to Barge

Flashings at each end and rivet to roof sheets

(1 rivet per 1 sheet) (fig.4).

IMPORTANT

Use 50mm Clouts only on ribs covered by flashings,

shown in fig.2. Predrill holes using a 3.5mm drill bit.

Use Roofing Screws on all other ribs and pans.

Ensuring screws are not overtightened as this can

damage the seal and cause the shed to leak.

SIDE

WALL

Barge

X 4

fig.3

Pan

= Clout

= Screw

TOP PLATE

BACK WALL

BOTTOM PLATE

RIDGE BEAM

FRONT WALL

fig.4

Spouting

Rib

fig.1

SIDE

WALL

fig.2