Duratuf GG97 조립 지침 매뉴얼 - 페이지 13

{카테고리_이름} Duratuf GG97에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf GG97 16 페이지.

페이지 인쇄

ROOF ASSEMBLY

SELECT:

5 x 2.200 m Roof Sheets

1 x 2.200 m 1 Pan Roof Sheet

2 x 2.725 m Spouting

4 x 1.102 m Barges

2 x 1.555 m Ridge Cap

1 x 2.690 m Ridge Beam

2 x 0.200 m Jack Studs

8 x 75mm Screws

37 x 55mm Roofing Screws

66 x Rivets

4 x 50mm Clouts

STEP 1:

• Place the Ridge Beam on a level surface and use 2 x 75mm

screws to secure the Jack Studs to the underside of the Ridge

Beam, one at each end (fig. 1).

• Turn the Ridge Beam /Jack Stud assembly over and place it on

the timber Top Plate in a central position.

• Secure with 2 x 75mm screws through the top of the Jack Studs

into the Timber Top Plate (fig. 2).

STEP 2:

• Position the first roof sheet with the centre slots over the

middle of the Ridge Beam. Gently fold the roof sheet over

the Ridge Beam so that the ends touch the front & back Top

Plates.

• Repeat with second roof sheet.

• Rivet sheets together at overlaps ,one rivet either side of the

ridge beam (fig. 3).

• Repeat with remaining roof sheets

IMPORTANT—FOR SHEDS WITH OPTIONAL CLEAR

ROOF PANEL

Assemble as below, making sure that the Clear Roof Sheets

overlap the standard roof sheets on both sides.

The Clear Roof Panel must be secured to the Top Plate and the

Ridge Beam. Pre drill and fasten with the 55mm roofing screws

provided..

SIDE

WALL

fig. 1

fig. 2

RIDGE BEAM

JACK STUD

TOP PLATE

fig. 3

TOP PLATE

BACK

WALL

BOTTOM PLATE

SIDE

WALL

RIDGE BEAM

FRONT

WALL