Duratuf KL1 조립 지침 매뉴얼 - 페이지 9

{카테고리_이름} Duratuf KL1에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf KL1 16 페이지. Kiwi series

KL3 DOOR JAMB & CORNER FLASHINGS

Step1: Fit Door Jamb Flashing (104) in between

Top and Bottom Plates and hard against

Stud. Attach Door Jamb Flashing with

three rivets into Rib on the outside and

three 30mm clouts into studs on the in-

side. Repeat with the other Door Jamb.

Step 3: Fit remaining three Corner Flashings over

corner Ribs and rivet in place using six riv-

ets per flashing. When fitting right hand Cor-

ner Flashing on the front wall, ensure it is

parallel with the Door Jamb.

Step2: Measure and cut Doorstep Flashing (106) to

fit in between Door Jambs. Position the Door-

step Flashing in between the Door Jambs at

bottom of doorway, nail through top of flashing

using three 30mm Clouts. Repeat with the

Overdoor Flashing (105).

Step 4: Position Ridge Cover (C109) on Ridge

Beam. While holding straight and square,

nail top of Ridge Cover Flashing to Ridge

Beam using four 30mm clouts. Rivet front of

Ridge Cover to Ribs and Flashings using

thirteen rivets.