Duratuf KL1 Інструкція з монтажу Посібник з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Зберігання на відкритому повітрі Duratuf KL1. Duratuf KL1 16 сторінок. Kiwi series
Друкувати сторінку
KL3 DOOR JAMB & CORNER FLASHINGS
Step1: Fit Door Jamb Flashing (104) in between
Top and Bottom Plates and hard against
Stud. Attach Door Jamb Flashing with
three rivets into Rib on the outside and
three 30mm clouts into studs on the in-
side. Repeat with the other Door Jamb.
Step 3: Fit remaining three Corner Flashings over
corner Ribs and rivet in place using six riv-
ets per flashing. When fitting right hand Cor-
ner Flashing on the front wall, ensure it is
parallel with the Door Jamb.
Step2: Measure and cut Doorstep Flashing (106) to
fit in between Door Jambs. Position the Door-
step Flashing in between the Door Jambs at
bottom of doorway, nail through top of flashing
using three 30mm Clouts. Repeat with the
Overdoor Flashing (105).
Step 4: Position Ridge Cover (C109) on Ridge
Beam. While holding straight and square,
nail top of Ridge Cover Flashing to Ridge
Beam using four 30mm clouts. Rivet front of
Ridge Cover to Ribs and Flashings using
thirteen rivets.
9