Duratuf MK4B 조립 지침 매뉴얼 - 페이지 5

{카테고리_이름} Duratuf MK4B에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf MK4B 16 페이지. Kiwi series, base size 4210mm x 3380mm

Note:

For sheds with the Raised Floor Modification option the studs will be 1.780m long to allow the Wall Sheets to pro-

trude 20mm below the Bottom Plate. Refer to Raised Floor Modification section (Page 15).

Step 1: Back Wall: Select one 4.210m Base Plate (Green), one

4.210m Top Plate (Red) and six Studs (Yellow). Lay out Plates

and two Studs on a flat surface and nail together using two

75mm nails per join. Nail in remaining centre studs using Nogs

to get correct position. Position Nogs .883m below Top Plate

and nail in place. (All Plates, Studs and Nogs are joined to-

gether with two 75mm nails each end).

Step 2: Front Wall: Select one 4.210m Base Plate (Green), one

4.210m Top Plate (Red), four Studs (Yellow) and two

1.185m Nogs. Nail studs to each end of Plates. Nail in re-

maining two studs using 1.185m Nogs to get correct posi-

tion. Position Nogs .883m below Top Plate and nail in

place.

Step 3: End Wall: Select one 3.380m Base Plate (Green), one

3.380m Top Plate (Red), three Studs (Yellow) and

two .787m Nogs. Lay out Plates and one Stud on a flat sur-

face and nail Stud centrally between Plates. Nail remaining

Studs to Plates using .787m Nogs to get the correct posi-

tion. Position Nogs .883m below Top Plate and nail in

place. Repeat with second End Frame.

MK4B TIMBER FRAME

JACK STUDS