Duratuf KIWI MK2A 조립 지침 매뉴얼 - 페이지 12

{카테고리_이름} Duratuf KIWI MK2A에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf KIWI MK2A 16 페이지.
Duratuf KIWI MK2A에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (18 페이지)

Step 1: Position Door Track (107) on front wall up

against underside of Roof, with right hand

end flush with the right hand corner. Pre-drill

hole in centre and rivet in place. Remove ALL

drill filings

Step 2: Hang door in Door Track. At the right hand

end of Door Track, adjust up or down so that

the Door hangs parallel with shed. Fit one

rivet at right hand end to hold in place. Repeat

with left hand end of track.

Step 3: Remove Door. Pre-drill holes into each Rib

and at similar spacings into Over Door Flash-

ing. At approximately 1/3 in from each end of

Door Track put a 50mm nail. Fix rivets to rest

of holes

Step 4: Clean out ALL drill filings. Also make sure

the Wheels are cleaned of drill filings. Re-

hang Door, then insert door stops into the

pre drilled holes at end of tracks as shown in

diagram. Tighten with two spanners

MK2A DOORS

Nut

Washer

Aluminium

Door Stop

Door Track

Washer

Bolt