Duratuf KIWI SHEDS MK3 조립 지침 매뉴얼 - 페이지 9

{카테고리_이름} Duratuf KIWI SHEDS MK3에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf KIWI SHEDS MK3 16 페이지. Base size 3380mm x 1715mm

MK3 FIXED WINDOW (Optional)

Step 1: Lay out the two window studs (883mm) and Nog

(590mm) on a flat surface. Position Nog and nail

in place using two 75mm nails at each end.

Follow Steps 2 - 5 on page 8.

Step 6: From the outside of the shed, place glass in Win-

dow Frame. Attach a Glazing Bead (G100) with

three rivets to each side of the Window Frame to

hold glass in place. Pre-drilling Glazing Beads is

recommended.

MK3 DOOR JAMB & CORNER FLASHINGS

Step 1: Fit Door Jamb Flashing (104) in between Top and

Bottom Plates and hard against Stud. Attach Door

Jamb Flashing with three rivets into Rib on the

outside and three 30mm clouts into studs on the

inside. Repeat with the other Door Jamb.

Step 2: Measure and cut Doorstep Flashing (106) to fit in

between Door Jambs. Position the Doorstep Flash-

ing in between the Door Jambs at bottom of door-

way, nail through top of flashing using three 30mm

Clouts. Repeat with the Overdoor Flashing (105).

Step 3: Fit Corner Flashing (101) over corner Ribs with the top

flush with the top of the Top Plate. Rivet in place with

six rivets, three each side. Repeat with other three

Corner Flashings. When fitting Corner Flashings on

front wall, ensure they are parallel with Door Jambs.

570mm