Duratuf KIWI SHEDS MK3 조립 지침 매뉴얼 - 페이지 11

{카테고리_이름} Duratuf KIWI SHEDS MK3에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf KIWI SHEDS MK3 16 페이지. Base size 3380mm x 1715mm

Note:

Condensation can form on the under side of shed roof. If building paper is required, fit now. Building paper will need to be sup-

ported by netting or roofing twine.

Step 1: Check that the diagonal measurements of the shed are the same. If building on unlevel ground it may be necessary to tempo-

rarily brace the shed with pieces of timber from the packaging.

Step 2: Position first Roof Sheet centrally over Ridge

Beam on the right hand end of shed with the

LIP on the left hand side. (For sheds with a

Clear Roof Panel, go to the next page). Posi-

tion the next Roof Sheet. Ensure it overlaps

correctly then rivet together, 400mm down

from the centre on both sides. Fit remaining

Roof Sheets.

Step 3: Starting from the left hand end, centralize Roof on

Ridge Beam. Ensure Roof is tight against end Wall

Sheets, predrill then nail one 50mm Clout through Rib

into the Ridge Beam. At the back, line up Ribs on the

Roof Sheet with the Ribs on Wall Sheet. Using one

50mm Clout, nail through Rib into Back Top Plate.

Repeat at the front.

Note The 6 x 50mm Clouts on end ribs are covered by the

Barge Flashings.

Step 4: Centralize Roof at the other end and nail through Rib

into the Ridge Beam and Top Plates, using 50mm

Clouts. Ensure Ridge Beam is straight, then Screw

one 50mm Roofing Screw into Ridge Beam through

each Rib on overlap (one screw per sheet). At the

back, set up a String Line in centre of Top Plate. En-

sure Top Plate is straight and screw, using one 50mm

Roofing Screw per Rib. Repeat at the front.

MK3 ROOF

LIP

50mm Clout

Roofing screws