Addonics Technologies DCED256ES 사용자 설명서 - 페이지 7

{카테고리_이름} Addonics Technologies DCED256ES에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Addonics Technologies DCED256ES 8 페이지. Diamond cipher aes 256-bit exdrive

페이지 인쇄

Power: Connect the 6-pin Mini DIN power cable (provided) to the 6-pin Mini

DIN power connector located at the back of the enclosure.

Data:

Model: DCED256ES

Connect the eSATA to eSATA cable to the eSATA connector located at the

back of the enclosure and the other end of the eSATA cable to the eSATA

connector on your SATA host controller with eSATA ports.

Model: DCED256EU

Connect the eSATA to eSATA cable to the eSATA connector located at the

back of the enclosure and the other end of the eSATA cable to the eSATA

connector on the USB2.0 to eSATA adapter. You can now plug the adapter to a

USB port on your system.

Powering On Enclosure:

Note: Be sure the Diamond cipher key is inserted into the drive enclosure

prior to turning on the power of the drive cradle. The hard drive will not

be detected by the computer if the power to the drive cradle is turned

on without the Cipher key. Under such condition, the power on the

drive cradle will have to be turned off and turned back on again with

the Cipher key already inserted into the drive enclosure in order to

detect the hard drive.

To power on the enclosure, move the switch located at the back of the

enclosure to the ON mode. When the switch is turned on, the LED light beside

it would light up to indicate power and also drive access.

Note: There are no drivers needed to use the eSATA cable as long as the

drivers are installed for the Serial ATA Controller card/chip. It is plug

and play.

Brand New Hard drive must be partitioned and formatted first before a

drive letter is assigned by the OS.

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)

Phone: 408-453-6212

Email: www.addonics.com/support/query/