Addonics Technologies DCED256ES Gebruikershandleiding - Pagina 7
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Addonics Technologies DCED256ES. Addonics Technologies DCED256ES 8 pagina's. Diamond cipher aes 256-bit exdrive
Pagina afdrukken
Power: Connect the 6-pin Mini DIN power cable (provided) to the 6-pin Mini
DIN power connector located at the back of the enclosure.
Data:
Model: DCED256ES
Connect the eSATA to eSATA cable to the eSATA connector located at the
back of the enclosure and the other end of the eSATA cable to the eSATA
connector on your SATA host controller with eSATA ports.
Model: DCED256EU
Connect the eSATA to eSATA cable to the eSATA connector located at the
back of the enclosure and the other end of the eSATA cable to the eSATA
connector on the USB2.0 to eSATA adapter. You can now plug the adapter to a
USB port on your system.
Powering On Enclosure:
Note: Be sure the Diamond cipher key is inserted into the drive enclosure
prior to turning on the power of the drive cradle. The hard drive will not
be detected by the computer if the power to the drive cradle is turned
on without the Cipher key. Under such condition, the power on the
drive cradle will have to be turned off and turned back on again with
the Cipher key already inserted into the drive enclosure in order to
detect the hard drive.
To power on the enclosure, move the switch located at the back of the
enclosure to the ON mode. When the switch is turned on, the LED light beside
it would light up to indicate power and also drive access.
Note: There are no drivers needed to use the eSATA cable as long as the
drivers are installed for the Serial ATA Controller card/chip. It is plug
and play.
Brand New Hard drive must be partitioned and formatted first before a
drive letter is assigned by the OS.
www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/