Contemporary Controls AI-SRVR-1485D 매뉴얼 - 페이지 14

{카테고리_이름} Contemporary Controls AI-SRVR-1485D에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Contemporary Controls AI-SRVR-1485D 20 페이지. Arcnet server to ethernet client

페이지 인쇄

All fields in the center and right columns of Figure 7 require numerical values:

IP Addr

Netmask

Gateway

DNS #1

DNS #2

Nodelist Timeout

FIFO Depth

TCP Port

UDP Port

EDITING IN FIELDS REQUIRING ENTERED VALUES:

in the Function field. Use the Tab key to advance from field to field. Within each field,

use the cursor arrow keys to position the cursor and the backspace key to erase

characters to the left of the cursor.

CTRL-V toggles the editing mode between the default OVERTYPE: OFF (characters are

inserted as you type) and OVERTYPE: ON (characters are replaced as you type).

EXPLANATION OF EACH FIELD

For the NETWORK configuration at the top of the screen, first set the Function to either

SERVER (if Ethernet clients are to access your ARCNET) or to PROXY (if you plan to

set up an Ethernet backbone between nodes in separate ARCNET LANs).

The Boot Protocol is the next item to be configured. If the IP address is to be set via

Dynamic Host Configuration Protocol, the DHCP option should be selected. When

DHCP is in effect, the following 5 fields are ignored:

DNS #1 and DNS #2. If a fixed IP address is to be used, then NONE should be

selected and the five fields listed in the previous sentence should be changed to values

that are appropriate for your Ethernet network.

* NOTE: If AI-SRVR units connect to the network through routers, this is the address of

the router through which access is gained to the rest of the network or to the Internet.

Next, the BRIDGE fields should be configured.

The Node ID can be any value from 1 through 255 so long as the designated value is

unique within the ARCNET network to which it belongs.

Speed can be set to 156kbs, 312kbs, 625kbs, 1.25Mbs, 2.5Mbs, 7.5Mbs or 10Mbs.

The 7.5Mbs option is not recommended, but it is provided if a special need exists.

* NOTE: The TB5 and CXB transceivers only support 2.5 Mbps. The 485X transceiver

only supports 1.25 Mbps, 2.5 Mbps and 5 Mbps.

is 192.168.92.68 by default.

placing the unit into service is highly recommended.

is the subnet mask — 255.255.255.0 by default.

is 192.168.92.1 by default. If your Ethernet LAN does not have a

gateway, set this value to 0.0.0.0.

is the IP address of the chosen Domain Name Server (if one is

desired at all). It is 0.0.0.0 by default.

is 0.0.0.0 by default.

is 1 by default, but can be set from 1–100000.

is 5 by default, but can be set from 1–10.

is 5001 by default.

TD000200-0MB

Defining a new address before

The default cursor position is

IP Addr, Netmask, Gateway*,