4B ETH-SWITCH1V4C-5P 운영 매뉴얼 - 페이지 12

{카테고리_이름} 4B ETH-SWITCH1V4C-5P에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 4B ETH-SWITCH1V4C-5P 16 페이지. Industrial ethernet switch

Below is the procedure that the end user must adhere to in order to maintain the system in a safe state.

1. Inspect that all the cabling is in good state and that all the electrical connections, including the

terminal blocks in the junction boxes are secure and in good order.

2. Make sure there is no water damage to the inside of the enclosure or any junction boxes used.

3. Verify that the LED marked POWER is illuminated red.

If the system does not immediately shutdown as expected or alarm as required, then remove the

machine from service until the problem has been diagnosed and corrected.

WARNING – EXPLOSION HAZARD – Do not connect or disconnect while circuit is live unless area is

known to be non-hazardous

AVERTISSEMENT - RISQUE D'EXPLOSION – Ne pas debrancher tant que le circuit est sous tension,

a moins qu'il ne s'agisse d'un emplacement non dangereux

POTENTIAL ELECTROSTATIC CHARGING HAZARD –CLEAN ONLY WITH A DAMP CLOTH

RISQUE DE CHARGE ÉLECTROSTATIQUE POTENTIEL - NETTOYAGE AVEC UN CHIFFON

HUMIDE SEULEMENT

DO NOT OPEN WHEN ENERGIZED

NE PAS OUVRIR LORSQU'IL EST ÉNERGISÉ

Manufactured by Don Electronics Limited, Westfield Industrial Estate, Kirk Lane, Yeadon, Leeds, LS19 7LX, United Kingdom

10. TESTING AND MAINTENANCE

WARNING

PAGE 12