Aplisens WW-11ALW 사용자 설명서 - 페이지 18
{카테고리_이름} Aplisens WW-11ALW에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aplisens WW-11ALW 20 페이지.
페이지 인쇄
EN.IO.WW.11.ALW
Local Menu
EXIT
PRESS
TEMP
MISC
UNIT
USER
SET LRV /
SET URV
XX.XXX
UNIT
+/-_____
LCD2DP
FILTR
LCD1VR
CURREN
PERCEN
The WW-11ALW display must be configured or the correctness of indications must be
checked after changing the measuring range of the transmitter connected to the display.
18
Return from Local Menu to display the process variable.
Set up of units.
Switching to the selection of pressure units.
Switching to the selection of temperature units.
Switching to the selection of different units.
Switching to the user's units entry.
Enter the user's unit value (six alphanumeric characters).
Buttons "↑" or "↓" are used to select each alphanumeric character of
the entered unit. Addition of successive character is made by confir-
______
mation of the previous character (by pressing [●] button). After con-
firmation of the last (6
mand with ''DONE" message or report an error number.
Function allows to assign the given
values corresponding to the output
signals 4 and 20 [mA]. Value after
linear scaling is displayed in the
LCD2 field. User can set any value of
start and end of the range. By default,
the LCD2 field displays the percent-
age of the measured range.
Table. Exemplary settings LRV, URV
Unit
mA
%
Measurement
range unit
(e.g. kPa)
Actual value of start and end of the displayed range will be present-
ed. Confirmation of this option allows to assign the given value to the
start and end of the displayed range.
Entering value of set range.
Buttons "↑" or "↓" are used to select entered character. Addition of
successive figure is made by confirmation of the previous one (press-
ing [●] button). Changing the digit or setting a comma is made using
button "↑" or "↓".After confirmation of the last (6
vice will confirm the command with ''DONE" message or report an
error number.
Parameter is entered in UNIT units.
Change the position of the decimal point of variable presented in the
LCD2 field of the display.
Selection of averaging time of displayed process variable.
Type of process variable presented in the LCD1 field of the display.
Value of current in current loop will be presented in the LCD1 field.
Percentage value of input setting will be presented on the display.
Description
th
) character, the device will confirm the com-
LRV
URV
4
20
0
100
Range
Range
beginning
end (e.g.
(e.g. 0)
100)
LCD2
Current in current loop
Output setting percentage
- set as a standard
Measured physical value
(e.g. pressure)
th
) character, the de-
Revision 01.B.003/2020.09