APlusLift HW-8S 설치 및 운영 매뉴얼 - 페이지 8

{카테고리_이름} APlusLift HW-8S에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. APlusLift HW-8S 19 페이지. 4-post portable storage car lift

Step 3 (Installing Cables)

• The cables come pre-installed in the runway along with the cylinder. Route the cables

in a manner in such that the two rear cables are in the front of the terminal block and

the front two corners are in the back of the terminal.

• Install the cables by running the ram manually by pulling it out on the ram by hand. Do

not add hydraulic fluid yet as the ram will not be able to be operated manually once

hydraulic fluid is added.

• Run cables through the pulleys on the cross rail and up towards the top of the columns

where there is a termination point.

• Attach the front lock release.

• Connect the release T rod with the long rod under runway.