APM SuperGuard PT-3 운영자 매뉴얼 - 페이지 6

{카테고리_이름} APM SuperGuard PT-3에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. APM SuperGuard PT-3 14 페이지. Personal tracker

3. Preparations

In order to use the Personal Tracker, the following preparations

should be carried out:

Prepare one operational GSM SIM card. Make sure that the SIM card can

operate without PIN protection and has GPRS with unrestricted Internet

access enabled (ask your GSM operator for APN and GPRS dial up

requirements). Empty the SMS storage of the SIM card using operational

GSM phone (please refer your GSM phone manual to do this).

Press the Power (INFO) button for 3 seconds to shut down the device.

1. Remove the back cover of the Personal

tracker by pressing up the battery release

lock and push the cover sideways.

3. Place the battery in the compartment

and reconnect it.

Press the Power button to power up the device.

2. Disconnect and remove the

battery. Insert the SIM card into

the SIM holder in the direction as

shown in picture.

4. Replace the cover and let it snap in

completely.

Battery Power Indicators:

If H LED flashes:

Device is powered on, with fully charged battery

If M LED flashes:

Battery power is medium

If L LED flashes:

Battery power is low

If all LEDs are flashing in sequence:

Battery is charging

Operational Indicators

If GPS LED flashes:

Device has GPS lock

If GSM LED flashes:

Device is registered to GSM network, able to send/

receive SMS and place or receive phone calls

If GSM LED stays on for a period of time:

Device is busy or searching for available GSM network

If GPRS LED goes on:

Device is dialing GPRS service. If connected, LED will

flash several times if connection to Control Base was

successful. Will repeat if not successful.

When SOS buttons are pressed for 2 seconds, all LEDs will

flash repeatedly and simultaneously.