APM SuperGuard PT-3 Operator's Manual - Page 6
Browse online or download pdf Operator's Manual for GPS APM SuperGuard PT-3. APM SuperGuard PT-3 14 pages. Personal tracker
3. Preparations
In order to use the Personal Tracker, the following preparations
should be carried out:
Prepare one operational GSM SIM card. Make sure that the SIM card can
operate without PIN protection and has GPRS with unrestricted Internet
access enabled (ask your GSM operator for APN and GPRS dial up
requirements). Empty the SMS storage of the SIM card using operational
GSM phone (please refer your GSM phone manual to do this).
Press the Power (INFO) button for 3 seconds to shut down the device.
1. Remove the back cover of the Personal
tracker by pressing up the battery release
lock and push the cover sideways.
3. Place the battery in the compartment
and reconnect it.
Press the Power button to power up the device.
10
2. Disconnect and remove the
battery. Insert the SIM card into
the SIM holder in the direction as
shown in picture.
4. Replace the cover and let it snap in
completely.
4. LED Status Description
Battery Power Indicators:
If H LED flashes:
Device is powered on, with fully charged battery
If M LED flashes:
Battery power is medium
If L LED flashes:
Battery power is low
If all LEDs are flashing in sequence:
Battery is charging
Operational Indicators
If GPS LED flashes:
Device has GPS lock
If GSM LED flashes:
Device is registered to GSM network, able to send/
receive SMS and place or receive phone calls
If GSM LED stays on for a period of time:
Device is busy or searching for available GSM network
If GPRS LED goes on:
Device is dialing GPRS service. If connected, LED will
flash several times if connection to Control Base was
successful. Will repeat if not successful.
When SOS buttons are pressed for 2 seconds, all LEDs will
flash repeatedly and simultaneously.
11