4D systems GEN4-FT813-43CT-CLB 시작하기 매뉴얼 - 페이지 4

{카테고리_이름} 4D systems GEN4-FT813-43CT-CLB에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 4D systems GEN4-FT813-43CT-CLB 10 페이지.

4D systems GEN4-FT813-43CT-CLB 시작하기 매뉴얼

SYSTEM REQUIREMENTS

The following subsections discuss the hardware requirements for this manual.

Hardware Requirements

1. Intelligent Display Module and Accessories
2. Host Controller
The gen4-FT812/FT813 (adaptor board and flat flex cable) should be
included in the box delivered to you after your purchase from our website
or through one of our distributors. Please refer to the section "What's in
the Box" for images of the display module and its accessories.
The gen4-FT812/FT813 is a display module which is driven by a host
controller. The host controller will send the commands using SPI
communication. It is entirely up to the user to select their host controller
and use it to drive the display.
Note: The host controller is a device such as an Arduino or a Raspberry Pi. These
devices are not supplied by 4D Systems.
gen4-FTDI Display Series - GETTING STARTED MANUAL
|
4