4D systems GEN4-FT813-43CT-CLB 시작하기 매뉴얼 - 페이지 5
{카테고리_이름} 4D systems GEN4-FT813-43CT-CLB에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 4D systems GEN4-FT813-43CT-CLB 10 페이지.
페이지 인쇄
CONNECTING THE DISPLAY MODULE
This section shows the complete instructions for connecting the display to
the host controller.
Hardware
Display Module
Connection Options
1. Connect one end of the FFC to your module's 30-way ZIF socket with
the metal contacts on the FFC facing up on the latch.
2. Connect the other end of the FFC to the 30-way ZIF socket on the
gen4-Breakout board with the metal contacts on the FFC facing up on
the latch.
3. Connect the pins of the gen4-Breakout to the pins of the Host
Controller.
1
FFC Cable
Adaptor
1
TO THE HOST
gen4-Breakout
Host Controller
Adaptor
2
1
gen4-FTDI Display Series - GETTING STARTED MANUAL
Cable
(FFC)
3
1
Software
Any Software which
can drive your host
controller
|
5