Apogee TS-100 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Apogee TS-100에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee TS-100 19 페이지. Fan-aspirated radiation shield
Apogee TS-100에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지)

페이지 인쇄

Wiring for ST-110 Serial Numbers 2725 and above

An excitation voltage of 2.5 V DC is recommended to minimize self-heating and current drain, while still

maintaining adequate measurement sensitivity (mV output from thermistor per C). However, other excitation

voltages can be used. Decreasing the excitation voltage will decrease self-heating and current drain, but will also

decrease thermistor measurement sensitivity. Increasing the excitation voltage will increase thermistor

measurement sensitivity, but will also increase self-heating and current drain.

Wiring for EE08-SS

*For more information, please see the EE08-SS manual:

Red: Excitation channel (excitation for

thermistor)

White: Single-ended channel (positive thermistor

lead)

Black: Ground (negative thermistor lead)

Clear: Shield/Ground

Red: Input voltage (7 to 30 V DC)

Black: Ground

Green: Single-ended channel (signal output by

air temperature sensor)

Clear: Ground (shield)

White: Single-ended channel (signal output by

relative humidity sensor)