Apollo 7100UL 설치 매뉴얼 - 페이지 15

{카테고리_이름} Apollo 7100UL에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apollo 7100UL 17 페이지. Residential & medium duty commercial slide gate operator

833/834 CONTROL BOARD ADJUSTMENTS

OFF

Program Switch #9

"Learn Mode"

Learn Mode

When switch #9 is in the 'ON' position, the controller is in learn mode. Learn mode is used to 'train' the

controller on the installation. Specifically the controller monitors the current draw and stroke length during

learn mode. This allows the controller to automatically set the auto reverse sensitivity of the installation in

addition to determining when to engage the soft stop feature.

When the controller is initially installed, it must be put into learn mode. The gate should be fully opened

and closed 3-5 times and partially opened and closed 3-5 times to allow the controller to adjust to the

weight and size of the gate. Program switch #9 should then be moved to the 'OFF' position to exit learn

mode.

Any changes to the condition of the gate (i.e. cold weather, rust, etc.) may require the controller to be put

into learn mode to train the controller once again.

Note: The controller must be put into learn mode any time that it is disconnected from the power supply.

Switch #9 Must Be In The OFF Position During Normal Operation.