Apollo Enclosures AE5550 설치 매뉴얼 - 페이지 12

{카테고리_이름} Apollo Enclosures AE5550에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apollo Enclosures AE5550 16 페이지. Environmental tv enclosures (with tv swing brackets) mastering the outdoor tv viewing experience from the inside out

페이지 인쇄

4. Attaching Mount Brackets to Rear of Back Panel

a. Use the four (4) holes for models 43", 50", 55" & 65" and (6) holes for models 75" & 86" with

threaded inserts in the back panel to attach the two (2) vertical mount brackets, included with the

wall mount. Use the following hardware provided with enclosure making sure to insert the hole

plugs in the unused holes.

b. Using hole plugs provided, insert with cone shape facing

4.1

55" and 60"-65" TVs with Low VESA Patterns -

Rear of Back Panel

IG1902 43-86 Swing A

(4) or (6) – Metric M6 X 20 screws

(4) or (6) – Stainless Steel washers

(4) or (6) - O-ring Rubber Washers

(4) or (6) – Rubber hole plugs

a. Remove 10 -24 lock nuts (2 places). They are not used with low VESA

pattern set up. Attach the TV vertical mount brackets (as shown in

step 3.1 above)

b. Insert the M6 metric screws and washers through the external TV

mount bracket.

c. Line the M6 metric screw and external TV mount bracket through the

top VESA mounting hole in back panel using the top threaded PEM

inserts in the internal TV mount brackets.

d. Once both brackets are situated, screw the bottom screws in place

and tighten all 4 screws to obtain a secured and sealed fit.

Page 12

IMPORTANT!

BE SURE THE O-RING RUBBER

WASHER IS PLACED BETWEEN THE

BACK OF THE ENCLOSURE AND THE

STAINLESS-STEEL WASHER TO

PREVENT WATER INTRUSION.

Attaching Mounting Brackets to Inside and

out.