Apollo Sprayers PRECISION-6 사용 설명서 - 페이지 6

{카테고리_이름} Apollo Sprayers PRECISION-6에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Apollo Sprayers PRECISION-6 18 페이지. Auto turbine

2.3 Preparing To Use Your HVLP Turbine System

Connect the air hose to the turbine. Pull back the spring loaded quick disconnect coupler and insert the male connector

on the air hose into the turbine connector. Release the ring. Your air hose will be locked into place. To release the air

hose, pull back on the spring loaded quick coupler ring with your fingers and pull. Connect other end of hose to spray gun

using this same procedure. Plug power cord into an outlet that is properly installed and grounded in accordance with local

codes and ordinances.

NOTICE

Do not cover or enclose the turbine. It is important to draw cool/ambient air through the unit for optimum

performance. Avoid placing the turbine in a warm environment or in direct sunlight. Do not spray in

ambient temperatures above 90 degrees. If you want to be able to spray in hotter temperatures, we

recommend placing a fan in front of your turbine to help it pull in cool air.

2.4 Familiarize Yourself with Your True HVLP™ Turbine Spray Gun

Refer to your Spray Gun Instruction Manual for information, setup and operation of your model spray gun.

You are now ready to spray your coating of choice on your work piece. Good quality results with your TrueHVLP™ spray

finishing equipment are a combination of careful preparation of your project, a proper spraying environment, a basic

knowledge of the coatings you will be using and how these coatings work with your TrueHVLP™ spray equipment.

Pressure will remain in the spray cup when unit is off. If you pull the trigger back, a stream of fluid

will flow. To prevent accidents, turn material flow screw clockwise until it is completely closed. The

trigger is now locked in the closed position.

NOTICE: It is not necessary to empty and clean your spray gun when you pause between applications. Be sure, however, to

clean your spray gun thoroughly at the end of your work session. Do not leave material in your spray gun overnight. Extra

caution must be taken when spraying coatings that have a catalyst or hardener added. These coatings can harden in your

spray gun quickly, making cleaning difficult or impossible. Read manufacturer's coating instructions as to how much time you

have before catalyst/hardener begins to set up.

Handi-Hold™ Spray Gun Docking Station

Every Precision-6 PRO turbine comes equipped with the Handi-Hold™

Spray Gun Docking Station (A), Apollo's smart innovation. Store, hold or

transport your spray gun in a vertical position with no risk of it falling over.

Ready to spray when you are. Disconnect hose from spray gun and insert

coupler into the Handi-Hold™ Spray Gun Docking Station (A), as shown.

Page 6