Apollo Sprayers PRECISION-6 Gebruiksaanwijzing - Pagina 6
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Apollo Sprayers PRECISION-6. Apollo Sprayers PRECISION-6 18 pagina's. Auto turbine
Pagina afdrukken2.3 Preparing To Use Your HVLP Turbine System
Connect the air hose to the turbine. Pull back the spring loaded quick disconnect coupler and insert the male connector
on the air hose into the turbine connector. Release the ring. Your air hose will be locked into place. To release the air
hose, pull back on the spring loaded quick coupler ring with your fingers and pull. Connect other end of hose to spray gun
using this same procedure. Plug power cord into an outlet that is properly installed and grounded in accordance with local
codes and ordinances.
NOTICE
Do not cover or enclose the turbine. It is important to draw cool/ambient air through the unit for optimum
performance. Avoid placing the turbine in a warm environment or in direct sunlight. Do not spray in
ambient temperatures above 90 degrees. If you want to be able to spray in hotter temperatures, we
recommend placing a fan in front of your turbine to help it pull in cool air.
2.4 Familiarize Yourself with Your True HVLP™ Turbine Spray Gun
Refer to your Spray Gun Instruction Manual for information, setup and operation of your model spray gun.
You are now ready to spray your coating of choice on your work piece. Good quality results with your TrueHVLP™ spray
finishing equipment are a combination of careful preparation of your project, a proper spraying environment, a basic
knowledge of the coatings you will be using and how these coatings work with your TrueHVLP™ spray equipment.
Pressure will remain in the spray cup when unit is off. If you pull the trigger back, a stream of fluid
will flow. To prevent accidents, turn material flow screw clockwise until it is completely closed. The
trigger is now locked in the closed position.
NOTICE: It is not necessary to empty and clean your spray gun when you pause between applications. Be sure, however, to
clean your spray gun thoroughly at the end of your work session. Do not leave material in your spray gun overnight. Extra
caution must be taken when spraying coatings that have a catalyst or hardener added. These coatings can harden in your
spray gun quickly, making cleaning difficult or impossible. Read manufacturer's coating instructions as to how much time you
have before catalyst/hardener begins to set up.
2.5 Get To Know Your Turbine
Handi-Hold™ Spray Gun Docking Station
Every Precision-6 PRO turbine comes equipped with the Handi-Hold™
Spray Gun Docking Station (A), Apollo's smart innovation. Store, hold or
transport your spray gun in a vertical position with no risk of it falling over.
Ready to spray when you are. Disconnect hose from spray gun and insert
coupler into the Handi-Hold™ Spray Gun Docking Station (A), as shown.
Page 6