Apollo Sprayers MOBILE MIST T100-S 사용 설명서 - 페이지 8

{카테고리_이름} Apollo Sprayers MOBILE MIST T100-S에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Apollo Sprayers MOBILE MIST T100-S 13 페이지. Tanning system

Adjusting the Mist Applicator™

a. Locate the Solution Flow Screw (#10) on the T6000 diagram.

b. Turning the Solution Flow Screw clockwise reduces and will eventually stop the flow of solution.

c. Turning the Solution Flow Screw anti or counter clockwise will increase the flow of solution.

d. In general, 1 ½ - 2 full turn from the fully closed position will provide a good solution flow. You may find that you

want more or less solution. You can adjust the Solution Flow Screw to your desired setting. NOTE

: Opening the

Solution Flow Screw more than 3 turns will not increase the solution flow and will in fact decrease the efficiency of

your Mist Applicator™

e. In general, hold the T6000 Mist Applicator™ 4" (10cm) from the person being sprayed. Moving the Mist

Applicator™ back will increase the size of the mist pattern. Moving the Mist Applicator™ closer will decrease the

size of the mist pattern. The further away you hold the Mist Applicator™, the more you will need to increase the

solution flow thus causing abnormal amounts of airborne solution (overspray).

f. Holding the Mist Applicator™ closer to the person being sprayed along with a minimum flow of solution will provide

the best results, no streaks or running solution and virtually no mist in the spray area.

g. Be sure to move the Mist Applicator™ at a slow, steady speed keeping the distance of the Mist Applicator™ the

same throughout the application. This will ensure perfect results. It is actually very easy. Practice a few times and

you will be an expert.

h. It is best to hold the Mist Applicator™ in a vertical position when spraying. If you want to change the direction of

the mist pattern, rotate the position of the air cap rather than turning the Mist Applicator™ on its side.

i. Always hold or store the Mist Applicator™ in a vertical position.