Apollo Sprayers MOBILE MIST T100-S Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Produkty higieny osobistej Apollo Sprayers MOBILE MIST T100-S. Apollo Sprayers MOBILE MIST T100-S 13 stron. Tanning system
Drukuj stronęAdjusting the Mist Applicator™
a. Locate the Solution Flow Screw (#10) on the T6000 diagram.
b. Turning the Solution Flow Screw clockwise reduces and will eventually stop the flow of solution.
c. Turning the Solution Flow Screw anti or counter clockwise will increase the flow of solution.
d. In general, 1 ½ - 2 full turn from the fully closed position will provide a good solution flow. You may find that you
want more or less solution. You can adjust the Solution Flow Screw to your desired setting. NOTE
: Opening the
Solution Flow Screw more than 3 turns will not increase the solution flow and will in fact decrease the efficiency of
your Mist Applicator™
e. In general, hold the T6000 Mist Applicator™ 4" (10cm) from the person being sprayed. Moving the Mist
Applicator™ back will increase the size of the mist pattern. Moving the Mist Applicator™ closer will decrease the
size of the mist pattern. The further away you hold the Mist Applicator™, the more you will need to increase the
solution flow thus causing abnormal amounts of airborne solution (overspray).
f. Holding the Mist Applicator™ closer to the person being sprayed along with a minimum flow of solution will provide
the best results, no streaks or running solution and virtually no mist in the spray area.
g. Be sure to move the Mist Applicator™ at a slow, steady speed keeping the distance of the Mist Applicator™ the
same throughout the application. This will ensure perfect results. It is actually very easy. Practice a few times and
you will be an expert.
h. It is best to hold the Mist Applicator™ in a vertical position when spraying. If you want to change the direction of
the mist pattern, rotate the position of the air cap rather than turning the Mist Applicator™ on its side.
i. Always hold or store the Mist Applicator™ in a vertical position.