Abusemark LCD 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Abusemark LCD에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Abusemark LCD 5 페이지.
Abusemark LCD에 대해서도 마찬가지입니다: 매뉴얼 (5 페이지)

AbuseMarK LCD Adapter Manual

LCD Adapter firmware features and

operation

When connected by USB or external 5V source, adapter defaults to full power on, with status LED

glowing BLUE.

One press on power button will switch to STANDBY mode, which turns off backlight, but keeps

DisplayPort connection. This mode is used to keep power consumption lower, or to save backlight

lifetime. In this mode, status LED is glowing RED.

To fully turn off the adapter (including disconnect from DisplayPort signals), press the power button

twice.

●→●→☀ (BLUE – full power on ‐> RED – standby ‐> Full power off (LED off)

Since most common use case does not involve disconnecting from DisplayPort (as this would cause

other monitors to flicker while display adapter is reconfiguring), if adapter is in standby mode for more

than a few seconds, pressing the power button returns to Full power mode, turning on backlight.

●→●→Wait 2+ seconds→● (BLUE – full power on ‐> RED – standby ‐> if monitor is in standby for a

few seconds, pressing Power again will go back to FULL power mode (BLUE LED).

Other features may be added via firmware updates at a later time.

This information is current as of 2013/12/17

12/17/2013